HV’Art Gesso Style Primer is a waterborne Polyurethane Primer developed for unsurpassed adhesion to a whole range of surfaces and is very forgiving for hand application.
It has a high pigment content and a high solids content, with excellent opacity and excellent filling power.
GSP is formulated to sand exceptionally well, with immediate powder-up, and an ultimate skin-like feel.
GSP can also be applied very successfully by Spray where required.
A range of 10 shades, including Pastel Undertones, White and black.
AREA OF USE:
All woodwork, joinery, furniture, kitchen cabinets & trim including picture frames, skirting board, doors & staircases. Wall surfaces, ceilings, coving.
METHOD OF APPLICATION:
Synthetic brush & fine-haired rollers
Ready for use depending on requirements, for best flow by brush GSP can be thinned with drinking water up to 20%, build will be proportionately reduced but coverage and opacity remain.
Solids content (%): 56 ± 1
Specific gravity (kg/l): 1.365 ± 0.030 Viscosity (DIN 6 at 20°C): 40” ± 8” VOC Content: 47 g/ltr
Recommended application weight: 150 to 250 per coat if applied by spray to timber substrate. No realistic maximum loading when applying by hand, as film weight cannot achieve this from manual application methods.
Touch dry (room temperature): 1 hour Sandable (room temperature): 4 hours sandable (by forced drying tunnel): 1 hour Sandable (by forced IR drying): 30mins
Drying times are indicative because they depend on temperature, humidity, & importantly air flow conditions.
Drying of waterborne products must take place at temperatures not below 15°C and at a relative humidity preferably not exceeding 85%. Out of these limits, there is a slowing down of the drying and/or formation of a less hard and resistant film. It is always advisable for drying to be forced, with air previously de-humidified and warm (20-30°C).